Unable to integrate fortimanager 7.4.8 with FGT 7.2.12 and others in gns3 lab

[AJ01]

Hi Everyone,

I'm trying to integrate fortinet firewalls v7.0.x, v7.2.x and 7.4.x with Fortimanager v7.4.8 and v7.4.7 but unfortunately unable to integrate to all in my gns3 lab however I was tried to do low encryption algo and ca cert and local cert according to fortimanager but no luck. Hence please help me out on it and share the steps to do the success lab. Thanks in advance 

[funkylicious]

hi,

what error do you get when you try to add a FGT into FMG ?

[AJ01]

Hi ,

I have enclosed error screenshots. let me know what i have to do next.

[funkylicious]

if you are using a FMG trial/demo, i would suggest using 7.4.5 in order to use https://community.fortinet.com/t5/FortiGate/Troubleshooting-Tip-How-to-solve-the-error-message-Could... 

if a entitlement/valid license is available, just upload it again and according to the KB it should be fixed.

[AJ01 · Accepted solution]

ok thanks trying to do lab with fmg 7.4.5 and let me know what specific commands need to be run over fmg and FGT 7.2.9 or 7.2.10 and older 7.0.9.

[AJ01]

thanks it's been integrated successfully.

please help me out to upgrade firmware from fortimanager because i'ts not uploading local images to upgrade firmware from fortimanager however it's taking too much time to upload image

[funkylicious]

you might need a valid support license/contract to do it from FMG, https://docs.fortinet.com/document/fortimanager/7.4.5/administration-guide/265384