Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
Aadar-Soomro
New Contributor

Un Even traffic distribution between 4 SDWAN zone members

Dear Community members,

 

I am facing the issue with SDWAN un even traffic distribution, i have chosen all available load balancing algorithms but most of the sessions are always build on single zone member. Also i setup the SDWAN rules, the interface selection is on manual mode and load balancing is enable between both.

1 REPLY 1
lgupta
Staff
Staff

Hello Aadar-Soomro, Good day!

Thank you for reaching out.

 

Can you please share the CLI output of the SDWAN rule you have configured?


config system sdwan

config service

show <sdwan-rule-name>

 

*Please obfuscate sensitive information before sharing the output*

Please refer these documents as well:
1. https://docs.fortinet.com/document/fortigate/7.4.6/administration-guide/723448/manual-strategy#LB-wi...
2. https://docs.fortinet.com/document/fortigate/7.4.6/administration-guide/342836/lowest-cost-sla-strat...

Regards.

Best regards,

-lgupta



If you feel the above steps helped to resolve the issue mark the reply as solved so that other customers can get it easily while searching on similar scenarios.
Announcements

Select Forum Responses to become Knowledge Articles!

Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.

Labels
Top Kudoed Authors