USB auto-install new firmware and factory-reset

[kiilerich]

Hi forum

I have a lot of new fortigates, direct from the box, that i need to upgrade(to version 7.0.9) and factory-reset after successful upgrade.

In trying to make a configuration file (fgt_system.conf) that reset the gate back to factory-default after successful upgrade of the new firmware image (image.out).

As of now im stuck in a "catch-22" problem :

The gate upgrades to the new firmware version, reboots, and then tries to load the config from the USB-drive

If the fgt_system.conf file on the USB contains e.g.

     execute factoryreset

    y

the gate get stuck in a endless reset loop.

All my attempts with auto-install scripts have so far also ended up in loops.

Anyone done this before or have any suggestions?

[Anonymous · Accepted solution]

Rather than trying to perform a factory reset within the fgt_system.conf, instead make your fgt_system.conf that of a factory reset fortigate on the target version / platform.

[gfleming]

Great response from FinNet. You could also look at using FortiManager to help manage all of these FortiGates.

[kiilerich]

Hi

Sadly the gates arrived with a version so old that it cannot connect to fortimanager. 

Im using fortimanger cloud and minimun version is 6.4.11 and boxes are with 6.2 out of the box.

So far only 2 solution seems to work.

Upgrade with USB and manual factory reset (console cli)

or

Upgrade with USB and a auto-boot of the fgt_system.conf  file containing the "default config" of the new version.

So far im sticking with the manuel process :(