- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Timeout on snmpwalk
Hello, I've noticed a strange problem on FortiOS 5.4.8, FortiGate 80D.
The SNMP is enabled and correctly configured. On my LAN interface, the SNMP is enabled, but I can't run a snmpwalk at all(timeout)
FW01 # diagnose snmpd: updating cache: idx_cache snmpd: trap request mem_low(0000000000000066) -> queue 1 in 0, 0 interval snmpd: queue is 0 entries long. snmpd: queueing trap 8000000000000002@1035799 (1035799) snmpd: queue is 1 entries long. snmpd: dequeueing trap 8000000000000002@1035799 (1035799) snmpd: sending to hosts: mem_low(102) snmpd: _trap4_prep:538 connect 169.254.0.1:162 vd=2 (type 3) errno=101 (Network is unreachable) snmpd: trap request mem_low(0000000000000066) -> queue 1 in 0, 0 interval snmpd: queue is 0 entries long. snmpd: queueing trap 8000000000000002@1037399 (1037399) snmpd: queue is 1 entries long. snmpd: dequeueing trap 8000000000000002@1037399 (1037399) snmpd: sending to hosts: mem_low(102) snmpd: _trap4_prep:538 connect 169.254.0.1:162 vd=2 (type 3) errno=101 (Network is unreachable)
if somebody know how to solve this issue or have an idea? pls advice me Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Make sure the SNMP Agent is enabled:
config system snmp sysinfo set status enable end
Also verify your trusted hosts and the configuration of your community:
https://kb.fortinet.com/kb/documentLink.do?externalID=FD45755
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
To add ensure allowaccess from cli or webUI has snmp allowed, if this is not added your snmp will fail and timeout.
e.g
config sys interface
edit wan1
set allowaccess ssh https snmp
end
Ken Felix
PCNSE
NSE
StrongSwan