- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Switch port connecting with Physical switch no work
Hello,
I have Fortigate 100E. When I connect the switch port to Physical switch, it does not active. Both ADMIN and physical showing is DOWN.
However, it's work fine for WAN1 port.
What should I do pre-setup to solve this problem?
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
if the admin status is down then the link status will never go up, or am I missing something here? So under Network > Interfaces the Switch is enabled on the FortiGate? What if you connect a normal client to on of the switch ports on the FGT, do you get a link?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Finally find because I have created new new Interface which is working as a switch mode.
It can be keep physical interface mode and now resolved.
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Did you admin up the original port? If you had it admin down then that is why it didn't come alive.
Mike Pruett
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Following up to see if you ever got this issue resolved
Mike Pruett
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yeah. I is working fine now.
Thanks!