Static route is showing but not configured.

[Shantilal1998]

Hi Guys,

I have not configured any static route but it is showing in the routing table.

Kindly suggest on the same.

[srajeswaran · Accepted solution]

Can you share the route detaiils? Is it a VPN route?

config vpn ipsec
    edit <name>
        set type dynamic
        set add-route {enable | disable}
    next
end

https://docs.fortinet.com/document/fortigate/6.4.5/administration-guide/534155/dynamic-ipsec-route-c...
https://community.fortinet.com/t5/Support-Forum/Static-route-is-showing-but-not-configured/td-p/2658...

[Shantilal1998]

Thanks..

It was resolved after adding.. set add-route disable..

[esalija]

add-route	Enable/disable control addition of a route to peer destination selector.	option	-	disable
	Option Description disable Do not add a route to destination of peer selector. enable Add route to destination of peer selector. https://docs.fortinet.com/document/fortigate/7.4.0/cli-reference/373620/config-vpn-ipsec-phase1

[Toshi_Esumi]

I know your immediate problem was solved by this. But you still need routes, either static or dynamic, to pass traffic over the VPN.

Toshi

[Shantilal1998]

I am using BGP for routes.

[Toshi_Esumi]

Or, is it a default static route(s) pulled via DHCP or PPPoE? Just show the GUI screenshot or "get router info routing-t all" in CLI.

Toshi

[nageentaj]

Hi Team,

Query :Static route is showing but not configured.
Could you please share us the current firmware along with the output of below commands
#get router info routing table details
#diag vpn ike routes

also please point out which route you are referring to in the routing table.

we will be waiting for the update

[Muhammad_Haiqal]

Hi @Shantilal1998 ,

This routing table will automatically shows:

1. PPPOE/DHCP interface
2. Connected interface
3. Dynamic routing (BGP/OSPF)

Hope it answer your questions.