Sonos/ Fortigate 60e / 7.2.1 / AP

DennisvanDriel · ‎09-18-2022

I have an Fortigate 60E with on port 7 with a Fortigate 48 ports switch connected trough Fortlink with IP adres 192.168.5.1 - 192.168.5.254.

On my FortiSwitch a have a VLAN ID 60 for Wifi with adres 192.168.2.1/255.255.255.0.

On port 40 of my switch i have an Fortigate AP (FC24JE). with adres 192.168.2.25

I have an WiFi SSID Sonos with adres 192.168.6.1/255.255.255.0.

I can registrate my Iphone on it an get an ip adres 192.168.6.25.

But i cannot install my Sonos with the Sonos ap. De app will not find my Sonos system.

How can i fix this.

With regards

Dennis

gfleming · ‎09-20-2022

It should work by default. You can try enabling igmp snooping on the VAP. Also check the status of these commands?

config system settings
set multicast-forward enable
set multicast-ttl-notchange enable
end

# config router multicast
set multicast-routing disable
end

Cheers,
Graham

View solution in original post

DennisvanDriel · ‎09-20-2022

I removed the Sonos App and installed it again.

I can see now my Sonos 1. So that is great.

But i get now an Error code 1001.

gfleming · ‎09-21-2022

Sounds like a Sonos issue then. Good luck!

Cheers,
Graham

DennisvanDriel · ‎09-21-2022

I need to open the following ports for the Sonos network.

All the ip adresses in 192.168.6.1/255.255.255.0

How can i do this?

gfleming · ‎09-21-2022

You don't need to open ports for intra-VLAN traffic. Unless you have specifically blocked intra-VLAN traffic on the FortiGate interface... but I don't think you have because you said your phone can see the system now.

Cheers,
Graham

DennisvanDriel · ‎10-08-2022

I set the above settings. Still it was not working.

Then i rebooted my fortigate 60e then the switch and at last the AP.

Then it was working.

With regards,

Dennis