Site-to-site VPN traffic between Sophos and Fortigate not be forwarded

[timchen]

I have 2 offices, Site A is Sophos and Site B is Fortigate. I have established Site-To-Site VPN for the two sites. The tunnel between the two sites is UP, but the Tunnel Interface IP cannot ping each other and the two sites cannot ping each other. The server under the site cannot ping the opposite endpoint.

The following is relevant information:

Site A (Sophos)

• WAN IP : 11.11.11.11
• LAN IP Subnet : 172.29.21.0/24, Server IP: 172.29.21.11 (LAN Gateway under Sophos Firewall)
• Tunnel Interface IP : 10.212.0.1/29
• Firewall Policy: Accept LAN(172.29.21.0/24) toVPN(10.210.101.0/24) 

Site B (Fortigate)

• WAN IP : 22.22.22.22
• LAN IP Subnet : 10.210.101.0/24, Server IP: 10.210.101.11 (LAN Gateway under Fortigate Firewall)
• Tunnel Interface IP : 10.212.0.6/29
• Static Route: 172.29.21.0/24 via interface S2S_DCOF_M
• Firewall Policy: Accept LAN(10.210.101.0/24) to S2S_DCOF_M(172.29.21.0/24)

  (Below Fortigate IPSec Tunnel Status)

Here I'm using Route-based to establish a Site-To-Site VPN connection, I've also tried Policy-based, but neither worked, and I'm not sure if I'm missing any settings.

I can't ping from the tunnel interface 10.212.0.1 to 10.212.0.6, nor does the reverse ping from 10.212.0.6 to 10.212.0.1.

and i tried the mtr from server, according to the server's mtr tracking, the data will stop at Fortigate's LAN Gateway

 

[dbhavsar]

Hello @timchen ,

- Can you make sure your tunnel IP subnet is being allowed in Phase2 selector.

[AEK]

And in firewall policies as well, and from both sides.

[timchen]

Hi @dbhavsar 

I have added the relevant IP address to the Firewall. I think it should be allowed, and the Phase 2 status is up. Is there any recommended way to check it?

[timchen]

In Fortigate, I have set up the Firewall Policy as follows, in which I include Interfaces using Zone.

Internal-LAN is server ip subnet interface, internal-S2S-OF is IPSec tunnel interface.

 

Sophos & Fortigate pretty much open up bidirectional firewall rules, except Sophos specifies the LAN IP and tunnel interface IP for both endpoints.

[AEK]

This troubleshooting tip shpuld help.

https://community.fortinet.com/t5/FortiGate/Troubleshooting-Tip-IPSec-VPN-with-Sophos-is-not-working...

[timchen]

Hi @AEK 

I conducted troubleshooting based on this document(https://community.fortinet.com/t5/FortiGate/Troubleshooting-Tip-IPSec-VPN-with-Sophos-is-not-working...), and it seems that the IKE Phase1 & Phase2 processes are smooth and there are no errors.

below are logs:

ike V=root:0:S2S_DCOF_M: link is idle 7 x.x.x.x(Fortigate WAN IP)->y.y.y.y(Sophos WAN IP):0 dpd=2 seqno=340 rr=0
ike V=root:0: comes y.y.y.y(Sophos WAN IP):500->x.x.x.x(Fortigate WAN IP):500,ifindex=7,vrf=0,len=80....
ike V=root:0: IKEv2 exchange=INFORMATIONAL id=8fdf995bf1a69d32/290c6f562da113ca:0000002a len=80
ike 0: in 8FDF995BF1A69D32290C6F562DA113CA2E2025000000002A0000005000000034E994E227B57A748E3C828E5510C2B08CA88979C167810B9AFF0A50C6BA984305B308DA3ACA67E990112A881C7AFDDF43
ike V=root:0:S2S_DCOF_M: HA state master(2)
ike 0:S2S_DCOF_M:15: dec 8FDF995BF1A69D32290C6F562DA113CA2E2025000000002A0000002000000004
ike V=root:0:S2S_DCOF_M:15: received informational request
ike 0:S2S_DCOF_M:15: enc 0F0E0D0C0B0A0908070605040302010F
ike 0:S2S_DCOF_M:15: out 8FDF995BF1A69D32290C6F562DA113CA2E2025280000002A000000500000003447D3FC98E47D420E5CEB95835779AFCBE67845F2E289A8639D2CC9A80897B7E26506A0C4477F635BFA6F2DAFF41F27E8
ike V=root:0:S2S_DCOF_M:15: sent IKE msg (INFORMATIONAL_RESPONSE): x.x.x.x(Fortigate WAN IP):500->y.y.y.y(Sophos WAN IP):500, len=80, vrf=0, id=8fdf995bf1a69d32/290c6f562da113ca:0000002a, oif=7

[Lelle68]

I would check the TTL and encryptions setting for phase1 and 2 matches between the two. I have stumbled over something similar between Sophos and Mikrotik. Tunnel was up but no traffic was forwarded

/Lennart