- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Setting up vlan fortigate 60e
- « Previous
- Next »
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
also i see that all the interface is in untagged mode only. the port you have connected to fortigate must be tagged mode if you create vlan in fortigate interface.
Regards
Mahesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mahesh,
for #3. try connect another laptop in switch and set ip address as 192.168.200.13 and try to ping the 192.168.200.12
I tried a PC 192.168.200.251 and laptop 192.168.200.12, both can see each other and cannot see the gateway 192.168.200.253 interface on the HP 1910 switch.
In my initial post, I thought we can setup VLAN on the fortigate, however as per analysis there should also VLAN ids setup on the switch. I tried asking HP forum guys about the unusual behavior of the hp1910, am not sure its working the way it should.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Mahesh/Ede, Can I ask for your suggestions what to do next? Here's what I plan to test further: After creating the VLAN: 10 on the FGT with IP 192.168.200.250, and I create also VLAN: 10 on the HP1910 switch with interface IP 192.168.200.253, connect the two devices via tagged port of the HP1910 switch, then on the PC or laptop I assign IP address 192.168.200.11 with gateway 192.168.200.253 Will the above VLAN work ?
- « Previous
- Next »