Sectional View missing?

[jtfinley]

Hi all. Logging into a Fortigate 60c (v4.0,build0513,120130 (MR3 Patch 5)), I no longer have the " Sectional View" option. I do not have " any" " any" settings on any policies to prevent it either. How do I get sectional view back? Joe

[jtfinley]

Never-mind, found someone else asked same question using keyword of " view" . Fortinet should update or get a better search function for their forums. The view options may not be available if - 1 - source & destination interfaces network are both set to " any" 2 - Fortimanager issue - resolved in later MR3p4+ ? FYI - config system global set gui-policy-interface-pairs-view enable end

[TopJimmy]

This was driving me nuts! There was nothing in the CLI manual about that command turning on the Section View just the cryptic:

Enable to make interface pairs visible in firewall policies. When disabled, all interfaces appear the same.

Thanks!!

[ede_pfau]

some more info on this: this is the article mentioned: http://support.fortinet.com/forum/tm.asp?m=82755 There was a quirk in FortiManager 4.3.2 setting the global setting to ' disable' by default. Using only one ' any' interface will force Global View mode on. And yes, this (the CLI Guide text) is by far the lamest description I' ve read in years. So all interfaces ' appear the same' ? Really? I' ll send a note to the doc team.