Secondary fortimanager devices fails

[lincoln29]

which action must be performed to return the FortiManager HA 1 manual mode to a working state?

[ndumaj]

Hello @lincoln29 

Well, you can switch the Primary node to Secondary using the command:

config system ha

set mode secondary

show

end

Please find below related article:
https://community.fortinet.com/t5/FortiManager/Technical-Tip-FortiManager-HA-failover-guide/ta-p/191...

BR

[ModEngine2]

To return the FortiManager HA 1 device to a working state after it fails in manual mode, you should first check the HA configuration to ensure it’s correct and synchronized. Re-enable HA mode from the primary FortiManager device, and verify that the necessary HA interfaces are connected and configured properly. Once HA mode is re-enabled, synchronize the secondary device with the primary one. Perform a failover test to confirm the devices are functioning correctly, and check the system logs for any errors or warnings related to HA. For further guidance, you can also refer to resources at modengine2.com.