Sdwan rules page shows nothing

[rezafathi]

Hi

Today I upgraded my fgt to 7.4.2 version but on sdwan rules page it does not show anything. In cli i can see my sdwan rules. What is wrong?

[CarlosKalyel]

Hi, version 7.4.2

[patiphan]

Agree!
I work around this by using this solution.

[hussainodk]

Could you please elaborate on the steps and describe the specific changes you made?

[CarlosKalyel]

Hello, of course.
On a Fortigate 200e that I updated from version 7.4.0 to 7.4.2 I had this problem on the SD-WAN page, so following this topic I deleted the rules with:

sdwan system configuration

configuration service

purge

end

After the page started working again, I tested by recreating the rules, and at a certain point I noticed that the page stopped working when adding more than one address as the origin in the rule.

However, I also have a 7.4.2 VM that I just installed, but the same problem does not occur.

[HALi]

7.4.3 same problem but randomly.....same problem on some other sections....

[Dhruvin_patel]

Hello Reza,

I understand you have a problem loading the sdwan rule page after upgrading to Fortios patch 7.4.2. 

There has been a known issue(ID) 0984478: SD-WAN Rules GUI Keep Loading

This issue is going to be resolved in patch 7.4.4. 

As a workaround, you can modify the sdwan rule using cli.

Regards!

If you have found a solution, please like and accept it to make it easily accessible to others.

[patiphan]

I did solve that by this step.

Root cause

-> from source or destination object on sdwan rule.

if you have many object on source/destination (more than 1 ) it not loading.

It problem only  sdwan rule is many object on source/destination.

Workaround

if you have many object on source/destination Please use Group object.

Solution

1. Create Group Object for sdwan rule.

2. edit only sdwan rule is to have many objects on source/destination (more than 1 ).

 -

    config system sdwan

    config service

    edit [rule id]

    set src "group object"

 next

end.

[hicham-azerzou]

the solution to your problem is to use one group object in source and destination adresses, if you use multi objects you will face the issue