I just ran into this issue:
On a FGT300E as well as on a 100E I enabled SNMP v1 and v2c and v3. Created a community for v1/v2c and a user for v3. Enabled SNMP on the interfaces where I need it. Just like it is written in Fortinet KB and Cookbook.
Thus on neither of both FGT SNMP v1 or v2c requests get a response from the FGT. SNMP V3 however works fine.
Since this happend to me on two different models running the same Firmware version this to me sounds like if that is broken in 5.6.10 :\
I already openend a Ticket with TAC upon this and will keep you updated.
--
"It is a mistake to think you can solve any major problems just with potatoes." - Douglas Adams
Nominating a forum post submits a request to create a new Knowledge Article based on the forum post topic. Please ensure your nomination includes a solution within the reply.
Maybe i am wrong but i think that when you enable SNMP v3, SNMP v1/2c automatically get disabled. So you can only use the "higher" version enabled. If you try to disable v3, does v2c works?
Orestis Nikolaidis
Network Engineer/IT Administrator
I think you are wrong. Enabling v3 on my FGTs does not disable v1 or v2c. However I tried with v2c ony and v1 + v2c before I tried v3.
--
"It is a mistake to think you can solve any major problems just with potatoes." - Douglas Adams
Select Forum Responses to become Knowledge Articles!
Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.
User | Count |
---|---|
1502 | |
1011 | |
749 | |
443 | |
209 |
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.