SNMP problem

[asda]

two fortigate 3240c，v5.4.10,build1220,180821 (GA)，created ha . All config is all right.

and i enable these

set ha-mgmt-status enable

set ha-direct enable

when i found both of them had  two conflict snmp-index.

master:port27 and mgmt had the same snmp index

salve:mgmt and vlan11(a logic port) had the same snmp index

So i first do the config on the slave to make sure all snmp-index are independent.

And machine did not reset ,but why the slave sync the master.Usually the slave does not sync the master.

Why it happened.And change snmp-index will not cause the machine reset,right?

master and salve have the same snmp-index with them mgmt,what will it effect?

thank you for your answer

[Stephen_G]

Hello asda,

Thank you for using the Community Forum. I will seek to get you an answer or help. We will reply to this thread with an update as soon as possible.

Thanks,

[srajeswaran · Accepted solution]

When you configure dedicated mgmt interface, the mgmt interface configuration is not synced between the Master and Slave and that's how they maintain different IP address on each node, i believe that could be the reason why you didn't observe SYNC issues (The only issue was with an interface whose config is not supposed to sync).

And change snmp-index will not cause the machine reset,right? No, it is not expected to cause device reset.
master and salve have the same snmp-index with them mgmt,what will it effect? It is not expected to create an issue.

[asda]

thank you very much