I'm using DAC SFP+ 10G cables from fs.com, programmed as Fortinet.
They are FINISAR modules, considered valid by the FortiGate 501E and FortiSwitch1048E.
Both FGT and FSW are running 7.2.2
However, every 3 minutes, sharp, modules are reset 'to recover from error state'.
Between reset, data flows correctly.
Is there anything to be done to avoid these module reset ?
Go to Solution.
I finally managed to clear the issue : disabling dmi just make the link work without reset.
When setting speed manually, the error message about module reset is still displayed every 3 minutes but the link is not seen as disconnected/reconnected by the server end.
View solution in original post
Thank you for using the Community Forum.
I will seek to get you an answer or help. We will reply to this thread with an update as soon as possible.
I have found this doc and from page 74 you have some explanation concerning ports:
Could you please tell me if it helped?
Verify if you are using the recommended compatible transreceiver:
If you still seeing issue then on FSW port connected with DAC SFP+ 10G, set speed 10000cr manually.
Ritesh P V
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2023 Fortinet, Inc. All Rights Reserved.