SDWAN Default Route not appearing in routing table

[velosy]

I have configured a default route via a SDWAN zone for Internet breakout traffic, this consists of two internet connections. The default route via this SDWAN zone is not being populated in the routing table, both interfaces are up and working.

For testing I set a default route out WAN1 and then WAN2 separately, they were both able to reach the internet and the default route was stored in the routing table.

Any possible ideas why the route is not being installed and working with the SDWAN zone?

[AEK]

You should see one default route with the two SD-WAN members, something like this:

FW # get router info routing-table details 
S*    0.0.0.0/0 [10/0] via 192.168.1.1, wan1
                [10/0] via 192.168.2.1, wan2