I am setting up a Fortigate 60E with SD WAN for failover/load balance but running into an issue.
I have 2 WANs connected and both work individually with my ipv4 policy if I switch between them, so I know the WANS are setup correct including the static routes. When I add them into SD-WAN and then set my ipv4 to use the SD WAN I have no internet at all. I feel I must be missing something obvious but I've followed the guides I've seen like this
Any ideas would be appreciated
Solved! Go to Solution.
Nominating a forum post submits a request to create a new Knowledge Article based on the forum post topic. Please ensure your nomination includes a solution within the reply.
You have also set up policy against the SD-WAN interface
Fortigate <3
I have setup a LAN to SD WAN IPv4 policy the same as I had for WAN 1 or WAN 2 but it now uses SD-WAN as outgoing interface
Yes
Are your dns correct, can you send ping to 8.8.8.8?
Fortigate <3
yeah it does seem like a DNS related issue, but the SD-WAN Status Checks is setup to ping 8.8.8.8 and it appears to be working. However I cant ping anything external including 8.8.8.8 from a client attached to it when im on the SDWAN so bit lost
pls check your routes
Fortigate <3
thanks - it was the routes I though leaving both wan routes in was correct but needed to chnage it so it only had the SD WAN Route
Select Forum Responses to become Knowledge Articles!
Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.
User | Count |
---|---|
1546 | |
1030 | |
749 | |
443 | |
210 |
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.