SD-WAN not working

[jase888]

I have 2 broadband lines I wanted to load balance and follwed the Fortigate SD WAN setup guide then tested at SD-WAN Status and it can ping Google and says link up, so I then add this as the outgoing connection on my LAN policy and it cannot get the internet.

Where am I going wrong? I should add when I use just the WAN as the outgoing connection it works fine so there must be some Im missing but Ive run through the guide 3 times now 

Any ideas?

[Fullmoon]

please check the ff.

SD WAN routes

Static Routes

Firewall Policy (NAT enabled)

Does it display correct routes in your routing monitor?

would you care to share what model and FortiOS are you using?

[siomyn]

If you configure sd-wan, make sure some configuration ;

1. Enable SD-Wan, put interface member and dont forget to put the gateway of each ISP

2. Create SLA to make sure link is up/down

3. Create defaut route to SD-Wan

4. Create policy from inside-to-sdwan with NAT enable

it should be OK