SD-WAN link selection based on link utilization

[nsm]

Hi,

I have below requirement

• Have 2 WAN links
• Need to steer the O365 destinated traffic by default from WAN1. If the WAN1 link was hit 90% percent of the bandwidth, need to be fail-over to WAN2. After the WAN1 utilization become fine need to fail-over again to WAN1.

Can we do this in SD-WAN?

[knaveenkumar]

Hi ,

Yes you can use sdwan spillover method and achieve this 

please refer the below article :

==========================

https://community.fortinet.com/t5/FortiGate/Technical-Tip-SD-WAN-usage-based-spillover-load-balance-...

Naveen 

[nsm]

Hi,

Yes I checked this. But Spillover is applied for the traffic that is not matched for any sd-wan rule.isn't it?. I need to steer only O365 related traffic not the all internet traffic.