Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
ms5080
New Contributor

SD-WAN interface select unable active pppoe wan1 and wan2 port

Hi I use the Fortigate 200e and firmware is ver.6.0.6. I wanna build SD-WAN with wan port1 and 2 which are pppoe ISP using. But open SD-WAN configration, cannot select of interface wan1 and 2.(don't display) Please kindly help above issue. Thank you.
1 REPLY 1
subramanis
Staff
Staff

Hello ms5080,

you can't add those interface if it's already referenced in any other configuration, and you have to remove the existing configurations associated  to those interfaces to add as a sdwan member.

 

Please check the firewall policy, static routes etc..

 Refer to the following link to check the interface reference on the existing configuration

https://community.fortinet.com/t5/FortiGate/Technical-Note-How-to-Check-Referenced-Objects/ta-p/1948...

 

Thanks

 

 

Top Kudoed Authors