SD-WAN how to route all internet traffic to WAN2

[Tutek_OLD]

Hi,

I have two interfaces in SD-WAN, now I would like that my WAN2 interface should be used for all internet access, now when I create SD-WAN rule I see here only as destination "Internet service" or "Application" I don't see here any "Service" option where I could add all HTTPS, DNS services needed for web browsing, so how could I do this?

[lobstercreed]

I think the answer is that you can't.  But it doesn't like you need to get that granular if you want *all* Internet access to go out wan2.  Just specify the source and destination addresses appropriately.

[Tutek_OLD]

Ok, but how to co figure destination addresses for all internet sites and services? As I said three is nothing here like destination with option 'all' something like on ipv4 policy.

[lobstercreed]

Sure there is...it's right above Internet Service and Application in the Destination section.  Choose the "all" address object.  It's probably already selected by default.

[Tutek_OLD]

My IPSEC tunnels are binded to WAN1 interface, If I create SD-WAN rule to redirect "all" source and "all" destination traffic through WAN2,  does this break my IPSEC tunnels or not?