SD-WAN and policy NAT 1:1

[it-andreagx]

Hello guys,
I have a dual WAN scenario and honestly I have some doubt.

I noticed that when the SD-WAN has been configured, I can't create any WAN to LAN policy.

There is a way to create a NAT 1:1 SD-WAN -> LAN policy?

Therefore, is this the the right way (set-up SD-WAN) to obtain this goal:
if the WAN2 (WAN2) fails or run out of bandwith, then activate the WAN1

TNX

[hbac · Accepted solution]

Hi @it-andreagx,

Yes, it is possible to create SD-WAN -> LAN policy and use Virtual IP for port forwarding (DNAT). Since you are using SDWAN, wan1 will take over if wan2 fails or vice versa. 

Regards,