SD-WAN Rules API connection

[AskingForHelp]

Hello Community,

The setup is a FortiWiFi 80F running v7.2.6 firmware. My goal is to know which port the SD-WAN has chosen and get that data from the API.

From the GUI, I access Network > SD-WAN > SD-WAN Rules

In the 'IPv4' Column and 'Members' Row this cell shows two ports along with a check mark. The check mark tells which adapter the SD-WAN rule is using.

How can I know what the SD-WAN has chosen from the API?

I have tried health check but have not seen what I am looking for

https://192.168.50.1:443/api/v2/monitor/virtual-wan/health-check?access_token=nwm3N6Nfsjp5szxtdG64hqn8g9s8sx

Appreciate it

[Raghu_Kumar · Accepted solution]

Dear Customer,

In the SD-WAN rules list, the interface that is currently selected by the rule has a checkmark next to its name in the Members column. However the cursor over the checkmark to open a tooltip that gives the reason why that member is selected, such as has best measured performance.

Does it show both the member as check marked ?

You can use session list or debug flow to see what port is being used for the outgoing traffic.

KB article for your reference:

https://community.fortinet.com/t5/FortiGate/Technical-Tip-Check-the-session-list-and-filter-by-IP-ad...
https://community.fortinet.com/t5/FortiGate/Troubleshooting-Tip-First-steps-to-troubleshoot-connecti...

[AskingForHelp]

Thanks this helps