- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
SD-WAN Failover
My job recently purchased a Fortigate 600D Enterprise firewall device. I am trying to route traffic to our 2nd internet service provider. I have the 2nd internet service provider plugged into a port thats configured as a WAN port. The Fortigate detects the connection and i see the green uplink icon but no traffic is going out the port. I configured one of our servers to send traffic directly to configured WAN port. I enable SD-Wan feature cause I plan on routing traffic from one ISP to another ISP. If one link goes down it sends traffic to the other ISP. The issue I'm having is getting the 2nd ISP to send traffic out its port. I double check to make sure the port i Configure for the 2nd ISP was a WAN. Any assisted would be greatly appreciated
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
first make sure you have configured the inside and outside NAT. ISP must have given you some router, make sure the NAT is done, then make sure the interface of FW is configured with the correct IP and proper routing is done. Failover can work when you define appropriate policy routes.
Regards,
Syed