Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
jr14
New Contributor III

SD-WAN DUAL-HUB-BGP

Hi, 

I have a dual hub topology active-active. I configure BGP on the hub with Capability: default originate enable, to inject the default route to the branch. 

In the branch i can see on the routing table 4 default route 2 for HUB1 and 2 for the HUB2..  

ex: Routing table branch

        0.0.0.0/0 [5/0] via 172.16.1.1, HUB-1-1_0 active   sdwan routes
                  [5/0] via 172.17.1.1, HUB-1-2_0 active
                  [5/0] via 172.16.2.1, HUB-2-1_0 active
                  [5/0] via 172.17.2.1, HUB-2-2_0 active

 

The question is.
It is possible or how can i do that in the branch fgt prefer o inject on the routing table the default route for HUB1 and just in case the connection for HUB1 is down, the FGT inject o prefer the default route for HUB2 ?? any idea ??

#sdwan FortiGate 

1 Solution
ebilcari
Staff
Staff

Have you tried the tag-match mode explained in the admin guide?

- Emirjon
If you have found a solution, please like and accept it to make it easily accessible for others.

View solution in original post

2 REPLIES 2
ebilcari
Staff
Staff

Have you tried the tag-match mode explained in the admin guide?

- Emirjon
If you have found a solution, please like and accept it to make it easily accessible for others.
jr14
New Contributor III

I will try it, thanks. 
I think this could word.

Announcements

Select Forum Responses to become Knowledge Articles!

Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.

Labels
Top Kudoed Authors