Route problem

[securitylearnercyber]

Hello Team,

I need some help, please.

I have an architecture where two FortiWeb ports are used. Both ports need to operate in one-arm mode and receive traffic from the Internet, as we have two firewalls connected to the two WAF interfaces performing DNAT.

Since it is only possible to configure a single default route, how can I make the FortiWeb accept Internet traffic on both ports simultaneously?

Note: I have already created a policy route, but it didn’t work.

Is there a way to make this work?

[funkylicious]

https://docs.fortinet.com/document/fortiweb/7.6.4/administration-guide/55130/configuring-the-network... 

[securitylearnercyber]

Thank you @funkylicious for the advice. What i was asking is not possible. Found another solution.