Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
lostboy10
New Contributor

Restarting httpsd on Fortimanager 7.4.1

I am facing a problem with fortimanager where after entering credentials GUI is stuck on blank page.. how can i restart https service from CLI ? 

 

i referred following article but these commands are not working on 7.4.1

 

https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-to-restart-kill-all-processes-with-fns...

1 REPLY 1
srajeswaran
Staff
Staff

As per the 7.4.1 CLI reference guide, the commands are as below.

 

system process

Use this command to view and kill processes.

Syntax

diagnose system process fdlist <pid> [list]

diagnose system process kill -<signal> <pid>

diagnose system process killall {Scriptmgr | deploymgr | fgfm}

diagnose system process list

 

Can you please check if there is a account privilege issue and try using admin account?

 

CLI Ref: https://docs.fortinet.com/document/fortimanager/7.4.1/cli-reference/677893/system#system_process

Regards,

Suraj

- Have you found a solution? Then give your helper a "Kudos" and mark the solution.

Top Kudoed Authors