Reset fortigate

[xook]

Hello Guys,

I am facing a big problem with our Fortigate 60F. I cannot access it. When I plug in the console cable, I cannot access the interface. Also, when I plug an Ethernet cable directly into my laptop, I still cannot access the Fortigate interface. The lights do not light up. I tried resetting it using the button, but nothing happens.

I appreciate your assistance.

[AEK]

Hi Xook

If you want to do a factory reset then follow this procedure:

https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-To-Reset-To-Factory-Default-Configurat...

Also you need a console cable and a tool to access the console terminal, like putty (serial 9600).

If this doesn't help then you should open a ticket fore hardware replacement.

[adimailig]

Hi @xook ,

You may follow the guide below to access the device via console.
https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-to-connect-to-the-FortiGate-console-po...

Try to reboot the device and check the logs from console access.
If there is no response from console / serial port and you still have valid license and subscription, I suggest to create a technical ticket to further check the issue and possibly request for RMA.

[DPadula]

Hi xook,

Did you keep the button pressed before the 30 seconds after you connected the FGT to power?

https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-To-Reset-To-Factory-Default-Configurat...

[RobertCook]

It seems you've covered most troubleshooting steps for your Fortigate 60F. If the console and Ethernet access methods aren't working, a factory reset might be necessary. My friend recommended https://domypaper.com when I was struggling with my coursework. The service was outstanding. The writer followed all my instructions and delivered a high-quality paper that earned me a top grade. I will definitely use this service again.