- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Reg:Branch Application
Dear Friends,
I have one doubt, we are using an application server with the IP of 10.60.X.X same has been am published through internet using VIP. Users can access the server internally and as well as from outside. In our branch we are using two different ISP s connected to the FortiGate 40C.Wan 1 is Internet and 2 is Leased line without internet.
From branch users accessing the application server from internally it will getting too slow. Is it any way to reroute the traffic via WAN1? (From internet getting good speed).Experts please advise…..
Many thanks,
ashok
ashok kumar
Network Engineer
CCNP/MCSA
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
you can use source routing, its under the route option were you can select the source address ( your branch lan) and destination is your application server VIP address ( since you want it over the internet).
FCSNP 5, JNCIS-FW,JNCIA-SSL ,MCSE, ITIL.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi am tried the same..but not working.....
ashok kumar
Network Engineer
CCNP/MCSA
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
can you share the interfaces from your branch and the routing table ( hiding your IPs).
FCSNP 5, JNCIS-FW,JNCIA-SSL ,MCSE, ITIL.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Destination IP :10.60.0.0.24
Device internal
Gateway 10.60.X.X
ashok kumar
Network Engineer
CCNP/MCSA