Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
ashok_kumar
New Contributor

Reg:Branch Application

Dear Friends,

                               I have one doubt, we are using an application server with the IP of 10.60.X.X same has been am published through internet using VIP. Users can access the server internally and as well as from outside. In our branch we are using two different ISP s connected to the FortiGate 40C.Wan 1 is Internet and 2 is Leased line without internet.

From branch users accessing the application server from internally it will getting too slow. Is it any way to reroute the traffic via WAN1? (From internet getting good speed).Experts please advise…..

Many thanks,

ashok

 

ashok kumar

Network Engineer

CCNP/MCSA

 

ashok kumar Network Engineer CCNP/MCSA
4 REPLIES 4
Fahad
New Contributor III

you can use source routing, its under the route option were you can select the source address ( your branch lan) and destination is your application server VIP address ( since you want it over the internet).

 

 

 

FCSNP 5, JNCIS-FW,JNCIA-SSL ,MCSE, ITIL.

FCSNP 5, JNCIS-FW,JNCIA-SSL ,MCSE, ITIL.
ashok_kumar
New Contributor

Hi am tried the same..but not working.....

ashok kumar

Network Engineer

CCNP/MCSA

 

ashok kumar Network Engineer CCNP/MCSA
Fahad
New Contributor III

can you share the interfaces from your branch and the routing table ( hiding your IPs).

FCSNP 5, JNCIS-FW,JNCIA-SSL ,MCSE, ITIL.

FCSNP 5, JNCIS-FW,JNCIA-SSL ,MCSE, ITIL.
ashok_kumar
New Contributor

Hi,

       Destination IP :10.60.0.0.24

Device internal

 

Gateway 10.60.X.X

ashok kumar

Network Engineer

CCNP/MCSA

 

ashok kumar Network Engineer CCNP/MCSA
Labels
Top Kudoed Authors