Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Redundant IPsec From 2 Interface to 1 Interface
Want to config 2 IPsec tunnel from different WAN1 to the Fortigate with only WAN1 Interface
Wan1 to Wan1 IPsec is working, I did config the same setting for WAN2 to WAN1 but getting negotiation error
IPsec Diagram:
WAN1-------IPsec----------Wan1
WAN2-------IPsec----------Wan1
1 REPLY 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I might have had the same.
This is probably due to the way Fortinet differs the tunnels.
I hade similar issues.
When I have two vpns that have the same proposals and use the same FGT als remote gw then one worked and one didn't and I say that was beause the remote gw FGT connected the 2nd to the wrong tunnel.
In Fact they only worked when they had different proposals...
--
"It is a mistake to think you can solve any major problems just with potatoes." - Douglas Adams
--
"It is a mistake to think you can solve any major problems just with
potatoes." - Douglas Adams
