Redist routes via BGP in Hub and Spoke

[chiklya1]

Hi!

I have setup an Hub and Spoke enviroment via the wizards.

The tunnel is up between the Hub and Spoke and I can see the BGP neighbours.

The problem is when I try to redistribute static routes from the Hub. They do appear in the routing table on the Spoke but they show as "Recursive" to the local WAN. So the traffic is not routed over the tunnel.

I did just add them under the BGP configuration on the Hub and toggled "Redistribute static".

What else am I missing? :)

[funkylicious]

hi,

i assume that you are doing iBGP with the Hub being the RR.

if so, under the bgp config do you use the update-source/interface param as the IPsec interface to the spoke peers ?