Reading sensor list of FortiAnalyzer CLI

[geloangelo101]

Hi Team,

I would like to check on how to read the power supply via CLI on FortiAnalyzer if its functioning well? I don't see any KB what this values stands for.

PS1 Status | 0x1 | discrete | 0x0100| na | na | na | na | na | na PS2 Status | 0x1 | discrete | 0x0100| na | na | na | na | na | na

Below output tells that power supply is ok right?

Sensor ID : PS1 Status (0xc8) Entity ID : 10.1 Sensor Type (Discrete): Power Supply States Asserted : Power Supply [Presence detected]

Sensor ID : PS2 Status (0xc9) Entity ID : 10.2 Sensor Type (Discrete): Power Supply States Asserted : Power Supply [Presence detected]

Thanks!

[PeterT]

You may use the  "exec sensor detail" command and page down to the PS1 and PS2 sections for details.  I could not find details to interpret the "exec sensor list"  output either.

genkdmw-flog02 # exec sensor detail

Sensor ID              : PS1 Status (0xc4)

 Entity ID             : 10.1

 Sensor Type (Discrete): Power Supply

 States Asserted       : Power Supply

                         [Presence detected]

Sensor ID              : PS2 Status (0xc5)

 Entity ID             : 10.2

 Sensor Type (Discrete): Power Supply

 States Asserted       : Power Supply

                         [Presence detected]