Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
jonniew
New Contributor

Quick mode selector is not working

Im trying to get up an ipsec VPN in interface mode. Im already set in the gui in p2 the Quickmode selector to source: 192.168.60.0/24 destination: 192.168.10.9/24 The debug output shows that is not working: ike 0:vpnipsec_m:1692:5682: peer proposal is: peer:0:192.168.10.0-192.168.10.255:0, me:0:192.168.60.0-192.168.60.255:0 ike 0:vpnipsec_m:1692:vpn_ipsec_m:5682: trying ike 0:vpnipsec_m:1692:5682: specified selectors mismatch ike 0:vpnipsec_m:1692:5682: peer: type=7/7, local=0:192.168.60.0-192.168.60.255:0, remote=0:192.168.10.0-192.168.10.255:0 ike 0:vpnipsec_m:1692:5682: mine: type=7/7, local=0:0.0.0.0-255.255.255.255:0, remote=0:0.0.0.0-255.255.255.255:0 ike 0:vpnipsec_m:1692:5682: no matching phase2 found ike 0:vpnipsec_m:1692:5682: failed to get responder proposal What could the reason ? What make I wrong ? Thanks for any help !
3 REPLIES 3
ede_pfau
SuperUser
SuperUser

Who is talking to whom? Which is local, which is remote? Seems to have source and destination the wrong way around. And, local side has wildcard selectors - at least the source side should be known.
Ede Kernel panic: Aiee, killing interrupt handler!
Ede Kernel panic: Aiee, killing interrupt handler!
jonniew
New Contributor

Hello Ede Thanks for your fast response: local is: 192.168.60.0/24 remote is 192.168.10.0/24 The 9 in 192.168.10.9/24 was a type error here in the ticket. I already tried to switch remote and local withot any success. I alway get the same debug output which shown that the selector in the firewall is ike 0:vpnipsec_m:1692:5682: mine: type=7/7, local=0:0.0.0.0-255.255.255.255:0, remote=0:0.0.0.0-255.255.255.255:0
emnoc
Esteemed Contributor III

this should be a clue? 0:192.168.10.0-192.168.10.255:0, me:0:192.168.60.0-192.168.60.255:0 and 0:0.0.0.0-255.255.255.255:0, remote=0:0.0.0.0-255.255.255.255:0 What are you connecting to ( fgt,asa,chkpt,sonicwall,etc....) ? What exactly do you have configured on phase2 local/remote proxy-id vrs what does the other end have config ? i.e src 0.0.0.0/0 port 0 dst 0.0.0.0/0 port 0 or src 192.168.60.0/24 to dst 192.168.10.0/24 ( a copy of the gui vpn ipsec monitor or show vpn ipsec phase2-interface would be better )

PCNSE 

NSE 

StrongSwan  

PCNSE NSE StrongSwan
Announcements
Check out our Community Chatter Blog! Click here to get involved
Labels
Top Kudoed Authors