I recently upgraded my 200B from 4.2.12 to 4.3.14 using the recommended upgrade path from 4.2.12 --> 4.2.15 --> 4.3.10 --> 4.3.14.
I have about 13 different custom categories. While all the categories came over properly, the action (Allow, Pass, Deny) did not come over.
When I try to assign a custom category as " Allow" or " Monitor" , I get the following error message when I try to apply it to a Web Filter profile:
" Invalid FortiGuard category. Cannot have the same FortiGuard category in multiple filters."
It doesn' t quite make sense to me that I can' t have the same custom category selected in multiple web filters, so I think the error message is incorrect.
Any suggestions on how to debug this one?
This was working fine in 4.2.12 before I upgraded.
Fortigate 600C 5.0.12, 111C 5.0.2
...using the recommended upgrade path from 4.2.12 --> 4.2.15 --> 4.3.10 --> 4.3.14.
Not at work to confirm this but I thought the direct recommended path to 4.3.14 is >=4.3.11.
Regarding your issue, I am guessing you may have a label(s) with an invalid char code and/or space char. I make it a habit of performing " debug config-error-log read" after each firmware upgrade to see if there are any errors or changes to the config. As well, I may go as far as putting the " before" and " after" configs through a text comparison tool.
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.