Problem with the debug flow

[franz]

Hello, i have a problem, when I enable the debugging(flow) I can not display any messages, why? debug output: enable console timestamp: enable diag debug flow show console: enable Thanks

[bmann]

This commands are right, but you' ve missed in manual other. diag debug flow trace start X where X in number of packets I think with diag debug flow filter ........... you can limit traffic to flow debug by IPs, ports etc.

[franz]

Hello, but also with the numbers it does not work....

[FortiRack_Eric]

perhaps start with diag debug enable to show output on console and diag debug flow show console enable diag debug flow show funct enable cheers, Eric

[franz]

Is the same.....don' t work :(

[red_adair]

Did you accidentally set a filter ? # diag debug flow filter It also doesn' t show Traffic that is offloaded to a NP2/NP4/SoC Network Processor. Only (eg in TCP) the initial Handhshake should be seen.

[franz]

No, i can' t view nothing... I view only with the " diagnose sniffer" is it possible that debugging is written to the flash?

[FortiRack_Eric]

nope, please post the output of diag debug flow filter perhaps your filter is wrong the std procedure for deb flow is: dia debug enable dia deb flow show console enable dia deb flow show funct enable dia deb flow filter <filters> dia deb flow trace start <no of packets>

[franz]

Yes i know, diagnose debug flow filter vf: any proto: any Host addr: any Host saddr: any Host daddr: any port: any sport: any dport: any sorry but don' t work...

[Schuler]

Do You have MR3? And a box bis NP2 asic? I' ve seen a similar behavior with a FG200B. I see traffic with " diag sniffer packet..." , but don' t see a session with " diag debug flow" .