I have 60E Fortigate Device i want to change it from NAT to transparent mode. but after that i can't access my device and when i contact with forigate wifi its also show me limited access . below is the code
-> config system settings
-> set opmode transparent
-> set manageip 192.168.10.20 255.255.255.0
-> set gateway 192.168.10.1
-> end
Nominating a forum post submits a request to create a new Knowledge Article based on the forum post topic. Please ensure your nomination includes a solution within the reply.
There are hardware switch and software switch in FSW60E, if you change the whole box into TP mode, L2 loop may occur and you can not access the gear then.
So what is the solution for it , please guide me
It depends on what topology of your network.
I suggest only two interfaces on one TP vdom only, if you want more interfaces, use different forwarding domain.
Please refer the following TP mode document.
Select Forum Responses to become Knowledge Articles!
Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.
User | Count |
---|---|
1710 | |
1093 | |
752 | |
447 | |
231 |
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.