Problem in transparent Mode

[irfanink]

I have 60E Fortigate Device i want to change it from NAT to transparent mode. but after that i can't access my device and when i contact with forigate wifi its also show me limited access . below is the code 

-> config system settings

-> set opmode transparent

-> set manageip 192.168.10.20 255.255.255.0

-> set gateway 192.168.10.1

-> end

[jnliu_FTNT]

There are hardware switch and software switch in FSW60E, if you change the whole box into TP mode, L2 loop may occur and you can not access the gear then.

[irfanink]

So what is the solution for it , please guide me 

[jnliu_FTNT]

It depends on what topology of your network.

I suggest only two interfaces on one TP vdom only, if you want more interfaces, use different forwarding domain.

Please refer the following TP mode document.

http://kb.fortinet.com/kb...teId=0%200%20105917848