Policy Based NAT might not be the correct term but what I am looking for is:
For the VPN tunnel, the remote subnet and local subnet are the same. With Cisco ASA, I would need to configure policy based NAT or identity NAT. However not sure how to do that with Fortigate.
Go to Solution.
If this is IPsec VPN, see the section on overlapping subnets. (Link is for 5.2).
NSE4/FMG-VM64/FortiAnalyzer-VM/6.0 (FWF30E/FW92D/FGT200D/FGT101E/FGT81E)/ FAP220B/221C
View solution in original post
Thanks :) I guess I was lazy reading the doc...
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2023 Fortinet, Inc. All Rights Reserved.