Hi all,
Really need someone advise on this issue. Below is my network setup.
I had purchased a public static IP address 12.xxx.xxx.218 from my internet provider.
I had a web server private IP address: 19.xxx.xxx.117.
I need to NAT the private IP address: 19.xxx.xxx.117 to public static ip address 12.xxx.xxx.218 so that i only need to input 12.xxx.xxx.218 on a web browser over the internet to access my webserver
In the end, i still cannot ping 12.xxx.xxx.218 after i done some NAT configuration inside the firewall.
Below is my firewall setup for NAT:
This is the firewall Port 13 interface
This is the firewall Wan1 interface
I had created a Virtual IP named NUC Gateway
- I had configure a LAN to WAN for internet access
- NAT is turned on
- I had created a Wan to LAN where i input my previous created virutal IP "NUC gateway" and selected at the Destination field
- I do not turn on NAT
Anyone experience on this setup, can advise what went wrong?
Nominating a forum post submits a request to create a new Knowledge Article based on the forum post topic. Please ensure your nomination includes a solution within the reply.
Hi AEK,
The problem is at the ISP side as they do not perform the routing properly. Quite surprise that they do not even test when they give me the Pubilc IP address
Select Forum Responses to become Knowledge Articles!
Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.
User | Count |
---|---|
1711 | |
1093 | |
752 | |
447 | |
231 |
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.