NAT webserver private ip address to a purchase public IP address issue

[rayha]

Hi all,

     Really need someone advise on this issue. Below is my network setup.

      I had purchased a public static IP address 12.xxx.xxx.218 from my internet provider.

      I had a web server private IP address: 19.xxx.xxx.117. 

      I need to NAT the private IP address: 19.xxx.xxx.117 to public static ip address 12.xxx.xxx.218 so that i only need to input 12.xxx.xxx.218 on a web browser over the internet to access my webserver 

      In the end, i still cannot ping 12.xxx.xxx.218 after i done some NAT configuration inside the firewall.

      Below is my firewall setup for NAT:

                      This is the firewall Port 13 interface

                This is the firewall Wan1 interface

    I had created a Virtual IP named NUC Gateway

- I had configure a LAN to WAN for internet access

- NAT is turned on

 - I had created a Wan to LAN where i input my previous created virutal IP "NUC gateway" and selected at the      Destination field

- I do not turn on NAT

     Anyone experience on this setup, can advise what went wrong?

[rayha]

Hi AEK,

     The problem is at the ISP side as they do not perform the routing properly. Quite surprise that they do not even test when they give me the Pubilc IP address