Created on
‎12-20-2023
07:31 PM
Edited on
‎02-26-2024
05:23 AM
By
Kate_M
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Monitor Interfaces for High Availability devices question
Dear All,
I have 2 x fortigate 201F with HA, port 23 & 24 were connected to each other for HA, may i ask for monitor interfaces which interface i should be added for this ? does it means if i added a interface for example port3, if this port3 were disconnected, the whole devices will be failover to the secondary device ? any help would be appreicated
piaakit
Solved! Go to Solution.
- Labels:
-
FortiGate
-
High Availability
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
- You should be monitoring the interface which are connected and passing the critical traffic in your network. Please refer the below document.
Regards,
Shiva
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
- You should be monitoring the interface which are connected and passing the critical traffic in your network. Please refer the below document.
Regards,
Shiva
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
as the current HA devices already configured sd wan with 2 circuits with load balancing, if i enable monitoring interfaces, does it means they have the same result to failover internet circuit
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
