- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Manual WAN1 configuration
Hello , could someone give me a light I'm configuring F60 , when the WAN1 card is set to receive DHCP modem from the operator it navigates normally , when I put it in Manual it stops navigating , I already went to the modem of the operator I made a DMZ I put the same IP and nothing someone could help me with this
Solved! Go to Solution.
- Labels:
-
FortiGate
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Either the ISP modem/router change the subnet on the interface or you need to change the subnet on the DMZ. Changing the addressing method from DHCP to Manual wouldn't solve the problem.
Toshi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Maybe you need to change your modem to Bridge mode? And did you create a static route for the default route?
Jerry
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Either the ISP modem/router change the subnet on the interface or you need to change the subnet on the DMZ. Changing the addressing method from DHCP to Manual wouldn't solve the problem.
Toshi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Could you explain this better? I have another firewall the way I said there is no DMZ
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I think that you need to check it with your ISP first to see what IP you can use on your FGT. Your ISP will help you to configure your modem if needed.
Once you get the addressing info from your ISP, you can configure it on your FGT.
Jerry
