Link Health Monitor using two default routes for one interface

[Eder_Lima]

Hello dear, How can I do so that only one of the routes to be removed, if two link health monitor configured in a single interface with two default routes? Here topology.

[ede_pfau]

As far as I have understood DGD will remove all routes associated with a port if the port's ping target fails. This will not only remove default routes.

One possible solution to this would be to use 2 WAN ports. Note that no 2 ports can be part of the same network though.

[Luiz_Alberto_Camilo]

You can also try dynamic routing between your fortigate and the ISP routers. This would dynamically remove one route in separate each time a link failure is detected. OSPF could be the functionality that best fits what you want to achieve.