- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Limited CLI commands available
Yesterday I was at a customer who had a transparent setup for UTM filtering.
I am not very familiar with transparent configurations, but the FGTs only had a few commands available to be run. For instance, 'diagnose' and 'get test' amongst others, were not available.
What could be the cause of this? They were running FW 5.2.4 on two 310Bs in HA. The admin account had super_admin rights.
Another question: A previous administrator had activated Web-Filtering on an inbound rule. What can be achieved from this? I don't understand how that would work.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
you need to go inside vdom or global to access the full CLI if the FGT has vdom enable.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
you need to go inside vdom or global to access the full CLI if the FGT has vdom enable.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jupiter_FTNT wrote:I am unfamiliar with VDOM operation.you need to go inside vdom or global to access the full CLI if the FGT has vdom enable.
Is this accomplished by:
config vdom
edit vdom_name
Or is there a separate root vdom management IP?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
1st you need to determine if your running vdoms to begin with, but a get system statsus should full-fill that purpose.
(e.g abbr output )
Virtual domains status: 2 in NAT mode, 4 in TP mode Virtual domain configuration: enable
2nd,
What could be the cause of this? They were running FW 5.2.4 on two 310Bs in HA. The admin account had super_admin rights.
That doesn't mean to much, what rigths permissions does the "super_admin" profile have? Was it changed to remove Read/Write access? ( basically look at the permissions in that account )
3rd
Another question: A previous administrator had activated Web-Filtering on an inbound rule. What can be achieved from this? I don't understand how that would work.
Maybe it's a typo or incorrect policy or traffic is indeed using this rule in another direction. You can enable logging and monitor the rule for activity over the course of 1-2 weeks and see if anything matches it.
IMHO: If your taking over an existing network, it's probably best to re-audit ALL rules for dupes, and poor rules or sequences.
PCNSE
NSE
StrongSwan
