I currently have my 1500D setup with three one gig connections going to my HP switch using LAN1, WAN1 and WAN2 with each of these using an IP address. I would like to create LAG ports so I can Increase the bandwidth and redundancy but I do not want to redo all my policy's and VIP's. Is it possible to create new LAG Ports with say LAN1 and LAN2 but having it listed as LAN1 still so the policies work and the same for WAN1 and WAN2 where I would LAG Wan1 with WAN3 and WAN2 with WAN4 but keep the ladled with WAN1 and WAN2 so that the policies and VIP's still work. I would use the same address on these LAG ports. Is this possible?
Thanks
Kevin
Nominating a forum post submits a request to create a new Knowledge Article based on the forum post topic. Please ensure your nomination includes a solution within the reply.
After reading my post again it should really be setting a LAG up for Port1 and Port2 and calling it LAN1 and keeping the policies and Port15 and Port17 as WAN1 and Port16 and Port18 as WAN2 but I need to keep all the VIP's and Policies, I hope this is a little clearer.
Thanks
Kevin
Select Forum Responses to become Knowledge Articles!
Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.
User | Count |
---|---|
1502 | |
1011 | |
749 | |
443 | |
209 |
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.