- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Issue with FG-60F
Hello
We have one faulty FG-60F that is still in guarantee. We wanted to get replaced but it looks like we need t complete HQIP first. But whne I tried to download test software from the page this appeared
I was not able to to find anything about those "built-in FortiOS hardware diagnostic commands" . Could you please help me.
- Labels:
-
FortiGate
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
In order to run a full hqip test you can use the command:
di hardware test suite
make sure that you will cable the interfaces following the instructions in the beginning of the test
Best Regards,
Nikos
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
you can find more information here:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you very much for your reply. May I ask you one more question I checked the guide but requires the device to actually boot and let me get to the CLI but my device does not get that far.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Did you try with console port?
Is there any output there when the device is trying to boot?
