- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
IPv6 WAN router advertisements?
Hi,
a few days ago i updated from 6.0.4 to 6.2 and now i got every 10 sec's this messages in the system log:
our AdvOtherConfigFlag on wan1 doesn't agree with fe80::1 our AdvManagedFlag on wan1 doesn't agree with fe80::1 our AdvOtherConfigFlag on wan2 doesn't agree with fe80::1 our AdvManagedFlag on wan2 doesn't agree with fe80::1
What is this message telling me?
Is the FG sending router advertisements to the wan interface and is reporting that it also get informations from fe80::1?
fe80::1 is the gateway IP on both WAN interfaces. (The provider)
The WAN interfaces are configured with DHCP.
Regards
Stefan
- « Previous
-
- 1
- 2
- Next »
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I found the cause of my issue. IPv6 had been enabled on my cable modem by my ISP, Spectrum. I was able to resolve the issue by going into System --> Feature Visibility and turning on IPv6. I then went into Network --> Interfaces opened up my WAN1 port settings and set IPv6 addressing mode to DHCP. I ended up having to reboot my cable modem a couple times and renewing the WAN1 IPv4 address a couple of times, but everything did stabilize out and these event messages went away.
Now I have a new set of log entries flooding my my WiFi events log: "Client {mac address snipped} had an IPv6 address detected (by NONE packets) ". Need to figure out if I need to do anything about those log entries.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
same issue on 7.2
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
On 7.0.3 and seeing it as well.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
7.0.5 Confirmed too
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Have it here on 7.0.2. Thought disabling IPv6 via Comcast would free up the issue. Nope.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
try this command if you dont need ipv6. it will stop logging
diag ipv6 devconf disable_ipv6 1
- « Previous
-
- 1
- 2
- Next »