Hi Community,
we have a fortigate vm with a ipsec tunnel. The tunnel is up, but in the IPsec Monitor it shows the phase 2 selector twice (same name, one up, one down). Also via snmp we get information for two phase 2 selectors with the same name.
We tried to recreate phase 2, reboot the fortigate and recreate the complete ipsec tunnel. It still shows the phase 2 selector twice.
Did somebody had a similar behavior in the past?
Nominating a forum post submits a request to create a new Knowledge Article based on the forum post topic. Please ensure your nomination includes a solution within the reply.
Hello
Check phase 2 selector of both FG, source and destination may mismatch. In that case the first tunnel attempt fails and shows tunnel down before re-establish the tunnel.
Thanks for this information. On the other side there was a ip address in phase 2 and on our side there was the subnet configured. We changed it from subnet to the ip address and phase 2 is now shown once.
Select Forum Responses to become Knowledge Articles!
Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.