i setup 2 IPsec tunnel with counterpart at AWS. the tunnel is working fine but there are 2 separate links showing that the tunnel is down.
how do i remove the unwanted tunnel.
phase2 selector route is down.
or shall i do i reset to bring up the tunnel.
Solved! Go to Solution.
Nominating a forum post submits a request to create a new Knowledge Article based on the forum post topic. Please ensure your nomination includes a solution within the reply.
Hi @yeowkm99 ,
You may run ike debug to check what happened.
ref- https://community.fortinet.com/t5/FortiGate/Troubleshooting-Tip-IPsec-VPNs-tunnels/ta-p/195955
Hello @yeowkm99 ,
Do you have two phase 2 configurations in the ipsec configuration? If you say yes, you can remove the second phase 2 configuration from the tunnel configuration. Or if you want to bring up this second phase 2 network, you need to add this network on the remote side also.
If it possible, can you share the ipsec phase 2 configuration with us?
Hi @yeowkm99 ,
Are they both Fortigate firewalls?
Try checking both end if the phase2 selector matches first.
regards,
Hi @yeowkm99 ,
You may run ike debug to check what happened.
ref- https://community.fortinet.com/t5/FortiGate/Troubleshooting-Tip-IPsec-VPNs-tunnels/ta-p/195955
Hi @yeowkm99 ,
Please check command result below.
# diag debug console timestamp enable
# diag debug application ike -1
# diag debug enable
Regards,
Jiyong
Select Forum Responses to become Knowledge Articles!
Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.
User | Count |
---|---|
1518 | |
1019 | |
749 | |
443 | |
209 |
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.